Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
- 13. Brake system
   13.1. Specifications
   13.2. Antiblocking system of brakes (ABS)
   13.3. Prorolling of hydraulic system of a drive of brakes with scanner use
   13.4. Check and adjustment of position of a pedal of a brake
   13.5. Check of the vacuum amplifier of brakes
   13.6. Prorolling of hydraulic system of a drive of brakes
   13.7. Adjustment of a course of a lay brake
   13.8. The vacuum amplifier of brakes
   13.9. Brake tubes and hoses
   13.10. A pressure regulator
   13.11. A brake pedal
   13.12. Replacement of lobbies brake колодок
   13.13. A support of a forward brake
   13.14. The main brake cylinder
   13.15. Replacement brake колодок on back drum-type brakes
   13.16. Replacement of the working brake cylinder
   13.17. A lay brake
   13.18. Hydraulic block HECU ABS
   13.19. The gauge of frequency of rotation of a wheel
   13.20. Search and elimination of malfunctions
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes




13.10. A pressure regulator

Do not remove a pressure regulator. The pressure regulator regulates pressure in a drive of brake mechanisms of back wheels depending on loading on a back axis of the car. With increase in loading it provides passage of a brake liquid to wheel cylinders of back brakes from what pressure in their contour raises and the overall performance of back brake mechanisms improves.

Check of function of restriction of pressure.

PERFORMANCE ORDER
1. Connect two manometres, one – on the entrance party and one – on the party of an exit of a regulator of pressure.

The prevention

After connection of manometres remove air from brake system.


2. Press a pedal of a brake and measure entrance and target pressure. If pressure are in limits of admissible amplitudes, as is shown in drawing, the pressure regulator is serviceable.
3. Remove manometres and connect tubes of brake system in initial position and remove air from brake system.

Installation of a regulator of pressure

PERFORMANCE ORDER
1. Connect tubes of brake system.
2. Tighten connecting nuts of fastening of tubes and remove air from brake system.

The moment of an inhaling of connecting nuts: 13–17 Н•м
The moment of an inhaling of nuts of fastening of a regulator of pressure: 8–12 Н•м